Waterjet Cutting
The latest in high-tech cutting has been added to the advanced machinery at Metal Moulding Corp.
Water pressurized to 60
000 psi is forced through a tiny opening with a small amount of garnet abrasive that will cut the hardest metals several inches thick. With a five by ten foot table and two cutting heads
this machine is productive and typical part tolerances range from + or - .005 of an inch.
This machine does an excellent job on stainless steel vents
drains
logos
brackets and thick aluminum.
Waterjet Advantage
* Minimum set up time
* No Tooling cost
* Multiple parts cut in a single pass
* High edge quality
* Narrow kerf saves material
* No heat distortion
High Polished
Vents
etc.
Designed by Metal Moulding
Click on any photo to enlarge.